找回密码
 欢迎加入盖氏论坛
搜索
查看: 7879|回复: 0

9V镍氢电池使用说明

[复制链接]
发表于 2008-1-10 18:32:04 | 显示全部楼层 |阅读模式
尊敬的客户:
     非常感谢您选用本公司的产品,为了更好的体现本产品的优良特性,请您在使用本产品时注意以下事项:
1.请您在开始充电前,先检测该电池组的开路电压。如果开路电压在8.5V以上时,建议您先以0.2~0.3C的电流将电池放至7.0V后,再开始充电。(注:1C=该电池的标称容量/1小时,以下相同。)
2.本产品不宜大电流充放电,充放电流一般不能超过0.3C。其充放电电流与充电时间的对照关系如下表:
  

充电电流

充电时间

放电电流

终止电压

0.1C

5小时

0.1~0.3C

7.0V

0.2C

7小时

0.1~0.3C

7.0V

3.如果本电池在经3个月以上的搁置后再重新使用时,请按小电流充放的使用方法活化1~3次。


                                           9V NI-MH BATTERY INSTRUCTIONS
Dear user:
    Thanks for choosing our product .To obtain the most superiority of this product, please read carefully below instructions before use :
1.   Check the open circuit voltage (OCV) of the battery pack before charge. If OCV remains 8.5 or above, It is recommended you discharge the pack with 0.2~0.3C to 7.0V, then proceed charging. (Note:C refers to pack nominal capacity)
2.   Do not charge/discharge the pack with high current, generally it should be controlled to be below 0.3C. please refer to the following current-duration relational table:

Charge Current

Charge Duration
Discharge Current

Cutoff Voltage

0.1C

15h

0.1~0.3C

7.0V

0.2C

7h

0.1~0.3C

7.0V


3. After a storage period longer than 3 months, before use activate the pack for 1~3 times with low current charge/discharge method.

本版积分规则

QQ|Archiver|手机版|小黑屋|盖氏网站 ( 苏ICP备14043903号 )

GMT+8, 2024-3-29 01:48 , Processed in 0.045511 second(s), 15 queries .

Powered by Discuz! X3.5

© 2001-2024 Discuz! Team.

快速回复 返回顶部 返回列表